B2 Audio Quattro Owner's Manual download pdf (Page 7)

3.3 Installation

+12V, GND, REM connection chart

Fuse

180A

Ground

Remote turn on

Main Battery

12V

Head unit

CAUTION

The minimum impedance as 1 unit is 1 .

In a daisy chain configuration the minimum

impedance is 2 .

Mono Speaker wiring diagram

Wiring layout

We recommend using 12 AWG speaker cables to obtain increased performance.

Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location

Keep the speaker cables seperate from the power cables and and the amplifier’s input cables.

Use grommets where the cables have to penetrate the vehichle’s chassis.

Connect the speaker wires according to the terminals on each speaker.

Strip 3/8" of insulation of the end of each cable and twist the cables strands together tightly.

Make sure there are no stray strands that might touch other cables or terminals and cause a short circuit.

Crimp spade plugs over the cable ends or tin the ends with solder to provide a solid terminal.

Connect the cable ends to the amplifer as shown in the speaker wiring diagram.

~ 1

1 2 3 4 5 6 7 8 9 10 11 12

No comments

B2 Audio Quattro Owner's Manual Page 7